💼 CM-6 Configuration Settings (L)(M)(H)

• Contextual name: 💼 CM-6 Configuration Settings (L)(M)(H)
• ID: /frameworks/fedramp-moderate-security-controls/cm/06
• Located in: 💼 Configuration Management

Description

a. Establish and document configuration settings for components employed within the system that reflect the most restrictive mode consistent with operational requirements using [Assignment: organization-defined common secure configurations];

b. Implement the configuration settings;

c. Identify, document, and approve any deviations from established configuration settings for [Assignment: organization-defined system components] based on [Assignment: organization-defined operational requirements]; and

d. Monitor and control changes to the configuration settings in accordance with organizational policies and procedures.

CM-6 Additional FedRAMP Requirements and Guidance:

Guidance: Compliance checks are used to evaluate configuration settings and provide general insight into the overall effectiveness of configuration management activities. CSPs and 3PAOs typically combine compliance check findings into a single CM-6 finding, which is acceptable. However, for initial assessments, annual assessments, and significant change requests, FedRAMP requires a clear understanding, on a per-control basis, where risks exist. Therefore, 3PAOs must also analyze compliance check findings as part of the controls assessment. Where a direct mapping exists, the 3PAO must document additional findings per control in the corresponding SAR Risk Exposure Table (RET), which are then documented in the CSP's Plan of Action and Milestones (POA&M). This will likely result in the details of individual control findings overlapping with those in the combined CM-6 finding, which is acceptable.

During monthly continuous monitoring, new findings from CSP compliance checks may be combined into a single CM-6 POA&M item. CSPs are not required to map the findings to specific controls because controls are only assessed during initial assessments, annual assessments, and significant change requests.

(a) Requirement 1: The service provider shall use the DoD STIGs to establish configuration settings; Center for Internet Security up to Level 2 (CIS Level 2) guidelines shall be used if STIGs are not available; Custom baselines shall be used if CIS is not available.

(a) Requirement 2: The service provider shall ensure that checklists for configuration settings are Security Content Automation Protocol (SCAP) validated or SCAP compatible (if validated checklists are not available).

Similar

• Sections
  • /frameworks/fedramp-high-security-controls/cm/06
• Internal
  • ID: dec-c-cf5a43a3

Similar Sections (Take Policies From)

Section	Sub Sections	Internal Rules	Policies	Flags
💼 FedRAMP High Security Controls → 💼 CM-6 Configuration Settings (L)(M)(H)	2		1

Sub Sections

Section	Sub Sections	Internal Rules	Policies	Flags
💼 CM-6(1) Automated Management, Application, and Verification (M)(H)			1